News

News

The ISBM50 injection-pull blow hollow molding machine is continuously produced in the user's factory for 200 days.


Our company's first ISB50 injection-pull-blow hollow molding machine was continuously produced in Shanghai Fengxian user factory for 200 days. Our company technical staff to visit the user, understand the use. Users of our equipment to give praise: "the quality of imported equipment, domestic second-rate prices, to create value for users".

1

Related News


Zhonghao Chenguang Equipment Debugging Successfully

On October 9-15, 2013, the technicians of Zhangjiagang Green Ring Company completed the installation and commissioning in the Third Factory of Zhonghao Chenguang Chemical Research Institute. The equipment was successfully debugged at one time, and the products after deoiling and stretching of the calendered film substrate were as follows: thickness 0.25mm, width 220mm, stretching ratio 5 times, meeting customer requirements.


PTFE rolling tape equipment successfully debugged in France

On December 20, 2013, the SFFD600 PTFE cable coated insulation tape rolling equipment produced by me was installed and debugged in a French customer company. Zhang Haifeng, an engineer of our company, took one week to complete the installation of the equipment and put it into trial production.


The ISBM50 injection-pull blow hollow molding machine is continuously produced in the user's factory for 200 days.

Our company's first ISB50 injection-pull-blow hollow molding machine was continuously produced in Shanghai Fengxian user factory for 200 days. Our company technical staff to visit the user, understand the use. Users of our equipment to give praise: "the quality of imported equipment, domestic second-rate prices, to create value for users".